I have revisited the automation API with MathCAD 15 today.
I raised this quesiton over 3 years ago, obvioulsy PTC do not think they need to update mathcad 15 or mathcad Prime and see automation as a low hanging fruit.
1. The automation API for setting values to a matrix is flawed and useless, and has been for three years now. You cannot set a matrix of any decent size without MathCAD crashing using the automation API. I had a large email trail for this in support three years ago!!!! PTC HAS DONE NOTHING TO ADDRESS THIS.
2. Prime is on Iteraiton 3. WHERE IS THE AUTOMATION API? The dvelopment of MathCAD Prime is pathetic. A decent API is essential, not only is MathCAD 15 flawed, but there is not even an API at all with Prime. How difficlt is it expose some basic functions in an API? The rate of developemnt of this product is pathetic. Three years after releasing PRIME and still NO automation API. I have given up on MathCAD at this rate. Obvioulsy MAPLE is the ony solution. PTC do not take take this prodcut seriously,